USER MANUAL · 4K VERTEX · REV 1.30
![4K Vertex diagram of the Scale Settings slide switch: No Scaling/Passthru, Custom Scaling [GUI], Auto Scaling](../assets/manual/p012-1.webp)
Scaler Settings
The three positions of the Scale slide switch: No Scaling/Passthru, Custom Scaling/GUI and Auto Scaling.
ALL CHAPTERS
GETTING STARTEDOverviewConnecting cablesPower / status OLEDReset HPD & factory defaultBackside stickerFRONT-PANEL CONTROLS & OLEDEDID mode selectionOLED / INFO controlInput switching & matrix modeHDCP settingsScaler settingsCombo RST + INPCombo INFO + INP (presets)OLED displayCustom EDID list (100 tables)SOFTWARE, UPDATES & CONTROLUSB driver (Windows)Firmware updateUSB GUI for WindowsRS232 controlAndroid / iOS appIR code listREFERENCEFAQHighlight featuresMain specificationsPro tipsCertifications
Scale slide switch has 3 positions.
The switch should be set to the middle position to allow control via USB, IR, RS232 or a Bluetooth device.
- No Scaling/Passthru
- What comes in/goes out, untouched.
- Custom Scaling/GUI
- This slide switch position will make use of custom defined scaling rules and allow change via Bluetooth, IR, RS232 or via USB.
- Auto Scaling
- In this mode, Vertex will auto-scale signals based on sink capabilities.
GLOSSARY TERMS IN THIS CHAPTER
Source: official User Manual 4K Vertex, Rev 1.30. Text and figures © HDfury, reproduced for Vertex owners.