USER MANUAL · 4K VERTEX · REV 1.30

Certifications

The FCC Class B and CE conformity statements for the Vertex and its CE, RoHS and FCC certifications.

ALL CHAPTERS

GETTING STARTEDOverviewConnecting cablesPower / status OLEDReset HPD & factory defaultBackside stickerFRONT-PANEL CONTROLS & OLEDEDID mode selectionOLED / INFO controlInput switching & matrix modeHDCP settingsScaler settingsCombo RST + INPCombo INFO + INP (presets)OLED displayCustom EDID list (100 tables)SOFTWARE, UPDATES & CONTROLUSB driver (Windows)Firmware updateUSB GUI for WindowsRS232 controlAndroid / iOS appIR code listREFERENCEFAQHighlight featuresMain specificationsPro tipsCertifications

FCC-B Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the measures listed below.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.

Notice 1

The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Notice 2

Shielded interface cables and A.C. power cord, if any, must be used in order to comply with the emission limits.

VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.

LegendSky Tech CO., LTD. — HDfury Vertex

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

CE Conformity

Hereby, LegendSky Tech CO., LTD declares that this device is in compliance with the essential safety requirements and other relevant provisions set out in the European Directive.

Certifications

Source: official User Manual 4K Vertex, Rev 1.30. Text and figures © HDfury, reproduced for Vertex owners.