USER MANUAL · 4K VERTEX · REV 1.30
![4K Vertex diagram of the HDCP Settings slide switch: HDCP 2.2, Follow Input [GUI], HDCP 1.4](../assets/manual/p011-1.webp)
HDCP Settings
The three positions of the HDCP slide switch: HDCP 2.2, HDCP Auto / GUI and HDCP 1.4.
ALL CHAPTERS
GETTING STARTEDOverviewConnecting cablesPower / status OLEDReset HPD & factory defaultBackside stickerFRONT-PANEL CONTROLS & OLEDEDID mode selectionOLED / INFO controlInput switching & matrix modeHDCP settingsScaler settingsCombo RST + INPCombo INFO + INP (presets)OLED displayCustom EDID list (100 tables)SOFTWARE, UPDATES & CONTROLUSB driver (Windows)Firmware updateUSB GUI for WindowsRS232 controlAndroid / iOS appIR code listREFERENCEFAQHighlight featuresMain specificationsPro tipsCertifications
HDCP slide switch has 3 positions.
The switch should be set to the middle position to allow control via USB, IR, RS232 or a Bluetooth device.
- HDCP 2.2 Mode
- In this mode you always have HDCP 2.2 (if supported) on both output ports. If incoming signal is 1.4 then output will be 1.4 too.
- HDCP Auto / GUI
- In this mode the Vertex unit makes sure that the conversion will always output a working signal. Both outputs are dynamic.
- HDCP 1.4
- In this mode, you always have HDCP1.4 on both output ports.
Note on HDCPBoth inputs accept HDCP1.4/2.2. Both outputs can work with HDCP1.4/2.2 devices.
Source: official User Manual 4K Vertex, Rev 1.30. Text and figures © HDfury, reproduced for Vertex owners.