VERTEX GLOSSARY / CONTENT PROTECTION

HDCP – HDfury Vertex glossary

HDCP 1.x / 2.x source and sink interoperability with configurable output handling; HDCP 2.2 on the outputs: the manual says both outputs (p.11) and elsewhere only the top output (p.107).

SIMPLY PUT

HDCP is a copy protection lock that HDMI devices use for films and TV shows.

The source and the screen must first agree on the lock (the handshake) before protected video is shown. 4K content usually needs the newer HDCP 2.2 lock.

If one device in the chain does not know that lock, you see a black screen or an error.

WITH THE HDFURY VERTEX

Does the HDfury Vertex support HDCP 2.2?

YESYes. Both inputs accept HDCP 1.4 and 2.2, and the Vertex converts 2.2 to 1.4 and back. For the outputs the manual differs: p.11 says both can do HDCP 2.2, p.107 says only the TOP output (p.11, p.107, p.110).

How to use it with the Vertex:

Leave the HDCP slide switch in the middle (Auto/GUI) for a working level on each output (p.11).
Check the HDCP version per input and output on the OLED Info page or in the GUI RX/TX lines (p.19, p.27).
Connect HDCP 1.x devices to the TOP output (p.5).
To force a level, use CONFIG > HDCP VERSION in the GUI (p.41).

HDCP Settings (p.11) →Unique HDCP Doctor (p.107) →

CONTENT PROTECTIONHDCP 1.x / 2.x

KEY POINTHDCP 1.x / 2.x

PURPOSEThe protected-content handshake layer.

VERTEXTechnical control layer

01 / SIMPLE EXPLANATION

What is it?

The protected-content handshake layer.

HDCP authentication occurs between HDMI devices before protected content is displayed. Vertex provides configurable interoperability handling for supported generations.

02 / REAL-WORLD USE

Why would you use it?

Useful in mixed-generation source, AVR and display chains.

In a Vertex system, this works together with the source, the connected sink(s), EDID/HDCP behaviour and the selected routing or processing configuration.

03 / HOW VERTEX USES IT

Inside the HDMI chain

HDCP 1.x / 2.x source and sink interoperability with configurable output handling; HDCP 2.2 on the outputs: the manual says both outputs (p.11) and elsewhere only the top output (p.107).

SOURCE → VERTEX → DISPLAY / AVR / PROJECTOR

04 / IMPORTANT TO KNOW

Do not confuse this with…

HDCP is separate from EDID, even though both affect whether an HDMI chain works.

This page explains the term in the context of the documented Vertex specification rather than as a general claim about every HDMI device.

RELATED TERMS

HDCPhandshakeauthenticationsourcesink

← BACK TO SPECIFICATIONS

QUESTIONS PEOPLE ASK

Common questions

Why do I get a black screen or HDCP error with 4K streaming through my old AVR?

Every device in the chain must support HDCP 2.2 for 4K content. The Vertex can convert between HDCP 2.2 and HDCP 1.4 so older equipment can still be used (p.107, p.110).

Which Vertex output supports HDCP 2.2?

The manual contradicts itself: p.11 says both outputs, while p.107 says 2.2 only on the TOP output. HDCP 1.x devices should go on the TOP output (p.5).

Is sparkling snow on the screen an HDCP problem?

Usually not. HDCP problems cause a black screen or an error message; snow or sparkles point to the cable or signal quality.